Tuffy-security 161 User Manual

Browse online or download User Manual for For the car Tuffy-security 161. Tuffy Security 161 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 1
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Page 1 of 1 - 9/2/2008 – Rev122006
INSTALLATION INSTRUCTIONS
Toyota Tacoma bed security lockbox, Part # 161
Please read and fill out the enclosed warranty registration card to activate your warranty.
Tools Needed
T-30 Torx
Mounting Directions
Note: The Tuffy lockbox can be mounted on either the right or left side of the bed depending on factory options
and preference.
1. Remove the (5) torx screws #4.1 holding the factory box in the bed then remove it from the bed.
2. Insert the Tuffy lockbox in the bed and fasten using the factory hardware #4.1 previously removed. The
bottom center screw is difficult but possible to install and is necessary for stability. If your tooling does not
get the screw tight we suggest using lock tight and then getting the screw as snug as possible. (See Figure
1)
3. Install the rubber seal #4.2 around the lip of the lid and #4.3 around rim of box as illustrated. (See Figure 1)
4. Check lock operation it may be tight at first until the seal gets compacted. Lock it Up!
FIGURE 1
ATTENTION:
FREQUENT LUBRICATION IS NECESSARY ON THE LOCKING SYSTEM
The lock contains a seal to protect the interior from dust and water. If this mechanism is not lubricated regularly it will become
difficult to operate. If this happens lubricate the lock with a light lubricant such as silicone spray. The lock will need to be
periodically disassembled and cleaned.
Call (970) 564-1762 for Technical Support
Page view 0
1

Summary of Contents

Page 1 - ATTENTION:

Page 1 of 1 - 9/2/2008 – Rev122006 INSTALLATION INSTRUCTIONS Toyota Tacoma bed security lockbox, Part # 161 Please read and fill out the enclosed warr

Comments to this Manuals

No comments