Tuffy-security 149 User Manual

Browse online or download User Manual for For the car Tuffy-security 149. Tuffy Security 149 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Page 1 of 2 – 12/20/06 – Rev10/12/2012
INSTALLATION INSTRUCTIONS
JK Glove box Part # 149
Please read and fill out the enclosed warranty registration card to activate your warranty.
Parts list
Glove box #6 Latch Bracket #4 Mounting Bracket #3 Door Stop
Shipping Package
#13.3 (1) 5/16 X 1” Bolt #13.2 (2) ¼-20 x ¾ Screws #13.5 (1) 5/16 Nylock nut
#13.1 (2) ¼-20 Wingnuts #13.4 (2) 5/16” Washers #13.6 (2) ¼” Washers
Tools Needed
#2 Phillips head screwdriver
7mm Socket, extension, and ratchet
10mm Socket
These are only required if the optional security step is done which requires drilling
½” Socket and ½” Wrench
Drill and 5/16” drill bit
Mounting Directions
1. Remove the factory glovebox by opening it until it stops then gently squeezing the sides together so the tabs clear the
frame then rotate and pull it all the way out.
2. Remove the factory lock catch at the top of the glove box opening in the dash by unscrewing the two screws.
3. Remove the original two screws #13.7 in the dash face that attach the plastic dash panel to the frame just below each
corner of the glove box opening. Save these screws you will reuse them. (See Figure 1)
Optional step to make installation easier:
2007-2010 JK (Not applicable to 2011-up): Pop off the plastic dash panel just below the glove box opening and remove
the two screws holding the dash panel to the frame. Save these screws you will reuse them.
Optional step to make installation easier:
2007-up JK: Remove the screw on the far bottom right holding the dash panel to the frame. This screw is next to the
metal side body wall just above the ground connection. Save this screw it will be reused.
Page view 0
1 2

Summary of Contents

Page 1 - INSTALLATION INSTRUCTIONS

Page 1 of 2 – 12/20/06 – Rev10/12/2012 INSTALLATION INSTRUCTIONS JK Glove box Part # 149 Please read and fill out the enclosed warranty registration

Page 2 - ATTENTION:

Page 2 of 2 – 12/20/06 – Rev10/12/2012 4. Remove the original two nuts #13.8 at the top inside the glove box opening by where the lock catch was remo

Comments to this Manuals

No comments